[ List Earliest Comments Only For Pages | Games | Rated Pages | Rated Games | Subjects of Discussion ]
Check out Janggi (Korean Chess), our featured variant for December, 2024.
Check out Janggi (Korean Chess), our featured variant for December, 2024.
The unfortunate part of my experience with 3D printing is that I have a dual-extruder machine, and I'm used to using a specialty support filament that breaks away easily. I forget that others don't have that option. In the case of the Walrus, though, they looked a little fragile from the start, but it wasn't until the full-size picture appeared here that I could see how extremely fragile they'd be -- I'd worry about them even with that specialty filament.
Either way, by the time you'd posted the above, I'd managed to re-do the Walrus, with the problem addressed two different ways: the tusks are thicker, and they actually embed into the bezel so supports may not be needed.
The heat here in the northwestern US started to affect me pretty badly by the time I was done, which is why it took until this morning for me to post it up.